Keeping Bathrooms Warm Without Blinding Your Guests
When you’re putting an infrared heater in a bathroom, the heat is the easy part. The real headache? The light. Think about it. You’ve got babies or elderly parents in the tub. The last thing they need is a glaring, bright-white halogen tube staring them in the face. It’s harsh. It’s distracting. Honestly, it’s a bit much for a relaxing shower. Taming the glare Standard short-wave lamps are basically spotlights. To fix that, we change how the light behaves. We use special quartz coatings and specific filaments to filter out that aggressive blue light. This pushes the energy into the medium or long-wave spectrum. The result? You still get that deep, cozy warmth on your skin, but the light stays soft. No more squinting. Dealing with steam and splashes Water and electricity are a nightmare pairing, especially in a steamy shower. That’s why we build these to an IP66 standard. In plain English: they’re dust-tight and can handle a direct blast of water without breaking a sweat. We use tempered glass and high-temp silicone gaskets to make sure no moisture ever touches the electrical guts. But here’s the catch. When you seal a heater that tightly, the heat gets trapped inside the box. If you use cheap wiring, the insulation will just melt. To stop that from happening, we use fiberglass-sleeved wiring. It can take the heat without failing. Getting it installed We made these to be simple drop-in replacements for standard ceiling mounts. They have a small footprint, so they actually fit into those cramped bathroom soffits without a fight. One quick tip: check your circuit breaker. These heaters have a bit of a “kick” when they first turn on. If your wiring is too thin or your breaker is under-rated, you’ll be walking to the electrical panel every time you want to get warm.Make sure your power can handle the surge.